Download Now
Brady 300 X-Plus II Driver

Brady Drivers by Seagull™ make it easy to print labels, cards and more from any true Windows program! Brady Printer THT X-Plus II Manual Online: Troubleshooting. Troubleshooting Troubleshooting If an error condition exists with the printer, review this. Brady BradyPrinter X-Plus II - label printer - monochrome - thermal transfer overview and full product specs on CNET.


DRIVER FOR BRADY 300 X-PLUS II

Type: Driver
Rating:
3.89
248 (3.89)
Downloads: 807
File Size: 6.40Mb
Supported systems: Windows 2008, Windows XP, Windows Vista, Windows 7/8/10
Price: Free* [*Free Registration Required]

Download Now
Brady 300 X-Plus II Driver

Brady X-Plus II Thermal Transfer Printer

On the sensor profile, this essentially corresponds to moving the peak of the graph up or down to optimize the readings for your application for more information, see Sensor Profile on page The media passes between the two. The upper Brady 300 X-Plus II sensor can be positioned along the inside half of the media the side closest to the Brady 300 X-Plus II of the printer or the outside half of the media the side farthest from the back of the printer.

Page 65 Printer Operation Adjust Sensors To adjust the upper media sensor for the outside half of the media: Remove the ribbon if ribbon is used. Locate the upper media sensor. The upper media sensor eye is directly below the adjustment screw head.

Brady X Plus II BP-X+II-R-FI Internal Rewinder Printer Field Installation Service - 80924

Locate the lower media sensor assembly under the rear roller. The sensor is a spring clip holding a circuit board.

BRADY 300 X-PLUS II DRIVER DOWNLOAD (2019)

Lower media sensor 2. Slide the sensor until the two brass-colored infrared emitters are under the upper media sensor. Make sure your labels and ribbon are right for your application.

Some media types require higher pressure to print well. For these media types, increase or decrease pressure using Brady 300 X-Plus II adjusting nuts until the left and right edges of the printed area are equally dark.

Contents Select a Print Mode Use the front panel controls Brady 300 X-Plus II set up the printer to the print mode that you wish to use. The following are the available print mode selections: The printer does not print another label until the first label is removed. The backing is wound on the rewind spindle, but the rewind plate is not used.

BRADY 300 X-PLUS II DRIVERS FOR WINDOWS MAC

Remove the rewind plate if installed from the front of the printer. Store it on the two mounting screws Brady 300 X-Plus II the inside of the front panel. The cutter is used to cut individual labels as they are printed. See www. Do not rub or touch the blade with your fingers.

Feed the labels through the cutter mechanism. Flip up the media supply guide.

Brady 300x-plus II Thermal Bar Code Label Printer for Special and Foil Labels

Slide in the media guide and media supply guide so they just touch, but do not restrict, the edge of the roll. The following illustration shows the printer loaded with labels in Rewind Mode. Remove the rewind plate from its storage location inside the printer.

Position the rewind plate so that the lip on the attached hook plate points down. If you have not already done so, install the rewind plate. From the front panel, select Rewind Mode. Turn the printer On I.

The printer feeds out and cuts one label. Before closing the printhead, make sure that: The label backing must be removed every time you change labels for the printer to work correctly. Contents Standard Ports

Other Drivers